Alto EQU MK II Series Manual do Utilizador descarregar pdf (Página 11)

5. INSTALLATION AND CONNECTION

5.1 Mains Connection

Please ensure that the equalizer is set to the correct supply voltage before

plugging the power cord into the wall outlet, use the same fuse as marked

on the fuse holder at the AC power connection socket. The mains connections

of the EQU MKII Series Graphic Equalizer is made by using the enclosed

mains cord and a standard IEC receptacle. It meets all of the international

safety certification requirements.

5.2 Audio Connection

The equalizer presents with balanced XLR and 1/4" TRS and unbalanced RCA

connectors. It can be interfaced in several ways to support a variety of

applications without any signal loss. The equalizer can be used on a single

instrument by connecting to the mixing console's main inserts, or on an entire

mix "in-line" between a mixing console's outputs and a power amplifier. The

defective wiring may degrade the performance of equalizer, so please use good

quality screened audio cables only. Please follow the guide below to interface

equalizer without experiencing any noise or signal loss.

Ok, you have got to this point and you are now in the position to operate your

equalizer successfully. However, we advise you to read carefully the following

section to be real master of your own equalizer. Not paying attention enough to

the input signal level, to the routing of the signal and the assignment of the

signal will result in unwanted distortion, a corrupted signal or no sound at all.

So you should follow this procedure for every single channel:

Strain Clamp

Sleeve

Tip

Ring

Sleeve=Ground/Screen

Ring=Right Signal

Tip=Left Signal

Use for Headphone

1/4" Stereo (TRS) Jack Plug

Strain Clamp

Sleeve

Tip

Sleeve=Ground/Screen

Tip=Signal

Use for Mono Line In, Mono 1/4" Jack Plugs

1/4" Mono (TS) Jack Plug

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Alto EQU MK II Series Manual do Utilizador Página 11