-Press to access the sub-menuENTER
-Select the EQ Type using buttonsUP/DOWN
-Press to confirmENTER
-The system asks confirmation of change: press to go on.ENTER
At this point the system loads a default FLAT preset of the same type of the selected EQ type.
To know what EQ type is currently loaded, click key, then select the item EQ Type using keys.UTIL UP/DOWN
Warning!
G2M: Graphical 2x15 Dual Mono
P2M: Parametric 2x15 Dual Mono
G2S: Graphical 2x15 Stereo
P2S: Parametric 2x15 Stereo
G1M: Graphical 1x30 Mono
P1M: Parametric 1x30 Mono
Only a preset belonging to the currently selected EQ Type can be loaded. If the user tries ie. to load
a parametric preset on a graphical equalizer, the system will refuse to load it and the display will show:
Warning! This preset cannot be loaded
9
To change EQ Type:
-Click Util key
-Select EQ Setup
Both the Factory and the User presets are classified by the EQ types described above. When the user is in
the Load Preset function an identifier in the lower right corner of the display describes the EQ type the preset
belongs to:
MIDI Setup: The MIDI SETUP utility allows the user to set up the CONTROL30 MIDI configuration.
The configurable MIDI parameters are:
Allows to define the MIDI CHANNEL to associate to the CONTROL30 when connectedMIDI Channel: to
remote MIDI devices. When MIDI CHANNEL is set to OFF, the CONTROL30 will ignore MIDI commands
coming from external MIDI devices.
When this function is set to ON, it is possible to ECHO on the MIDI output of the CONTROL30MIDI Output:
all the incoming MIDI messages.
Output Attenuation: This control allows the digital output volume setting. This parameter is a system
para-
meter and its modifications act on all the presets.
Bypass Button (14): Using this button is possible to bypass the process, sending to the CONTROL30
out-
puts exactly the input signals. This is a digital bypass and the input signal is anyway converted digitally
before being sent to the outputs. When the CONTROL30 is in this mode (Bypass LED (5) = ON), all the
buttons except the" bypass" button are disabled.
Up/Down Button (8/9): These buttons are used to navigate the menus and to modify the parameter values.
Enter/Esc Button (10/11): These buttons are used to access or to leave the menus or to confirm the para-
meter values.
Edit Button (12): This button allows the user to enter the EDIT Menu (the Edit LED(3) will be ON). When
entering the Edit Menu, the user will be able to access and modify all the parameters related to the process.
When the user modifies one parameter value, the LED (1) starts to blink to signal the update. The LED will
blink until the storing of the new modified preset in one of the available locations.60
VU-Meter: This function allows the user to use the VU-meters (6) to show the input signal level or the digital
output signal level.
LED Meter (2): This LED is ON when the VU-meters are showing the digital output level and is OFF when
the VU-meters are showing the analog signal input level.
(15 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais